HELP!!!!
Reply
|
BandGeek22
Bracelet King
 |
4 years, 8 months ago by BandGeek22
I can’t get the loops down to start a bracelet. I can’t tape it down it always comes off the table and every time I get to the point where I tie a knot to connect it in the middle I can never get it tight enough and I have a line of string at the top. Idk what to do and I can not get the start of any bracelet. A loop triangle ends just I can’t get any start down any tips anyone? I need help!!! Hopefully that made sense lol I am not the best at explaining things 😐
|
|
sushi_06
Bracelet King
 |
4 years, 8 months ago by sushi_06
I totally understand your problem, and it's something I struggle with too. I think over time you'll develop your owns ways to fasten your loops but, you could try using a safety pin to fasten the loop to a pillow or piece of fabric. You could even fasten it to your pants, which I sometimes do while I'm watching TV. Then you can get both sides of the loop closer together, and it should be easier to connect the two sides. I also like to do a thinner piece of tape that goes over the loop vertically, which seems to prevent it from slipping out. I hope this was helpful. 👍 🙂
|
|
BandGeek22
Bracelet King
|
4 years, 8 months ago by BandGeek22
@sushi_06 thank you!!!! 💖
|
Reply
