Alpha Keychain Help!
Reply
|
Abby_Askew
Skiller
 |
4 years, 4 months ago by Abby_Askew
I have recently been using alpha patterns to make keychains like I have seen in some photos on patterns, however the past two that I have made have turned out super elongated and look different than the other photos I’ve seen. My end product is always more stretched out vertically and looks a little distorted and I was wondering if anybody had tips to avoid this or could explain why this is happening
|
|
Clairaland
Bracelet King
 |
4 years, 4 months ago by Clairaland
So this is most likely happening because of your knotting structure (it gets better with practice) your knots could be too loose
|
|
madeleine_
Moderator
 |
4 years, 4 months ago by madeleine_
You should try tying your knots tighter
|
|
diylover14
Advanced
 |
4 years, 4 months ago by diylover14
You should try to make the knots more consistent. It gets better with practice 😊
|
|
RAVENC
Professional
 |
4 years, 4 months ago by RAVENC
Making knots tight is the best but if you pull too tight the strings can snap so be careful
|
|
rmg_becca
Professional
 |
4 years, 4 months ago by rmg_becca
Try to make the units tighter and pull the tighter more but remover if you pull to tight a string can snap
|
|
jemmm_boo
Skiller
 |
4 years, 4 months ago by jemmm_boo
tie your knots tighter and also try to finish the bracelet at around the same time that you started it so that your knot tension doesn't change too much. hope this helped
|
|
Abby_Askew
Skiller
|
4 years, 4 months ago by Abby_Askew
Thank you all so much! I will keep practicing!
|
Reply
