String Length for pattern #10901 (kinda urgent)
Reply
|
NG17
Professional
 |
3 years, 11 months ago by NG17
I know this may be a common question. But can someone please tell me how long should each string be for pattern #10901.....If I am starting with a loop. Pleas its kinda urgent.
|
|
2006_Mandy
Bracelet King
 |
3 years, 11 months ago by 2006_Mandy
If I were making that pattern I would cut 1 meter per string to fold in half and then add in more thread if needed.
|
|
NG17
Professional
|
3 years, 11 months ago by NG17
Thanks a lot @2006_Mandy
|
|
danielle_3
Bracelet King
 |
3 years, 11 months ago by danielle_3
i usually cut my string at a wingspans length for each thread. to measure a wingspan just hold the string in one hand and stretch it across your chest and then cut the string at the point where it reaches your other hand. i recommend you cut the string you're making the loop with a little bit longer. the strings that are used most in the pattern could be cut longer. you can always replace the strings if they get too short though!
|
|
NG17
Professional
|
3 years, 11 months ago by NG17
Thanks @danielle_3
|
|
Crafty_K
Bracelet King
 |
3 years, 11 months ago by Crafty_K
Hello, I would usually, for any normal pattern, cut my strings to be about a wingspan and a half, and then double them over. It depends on your wrist size, but in general, a wingspan and a half would make a good 5-inch bracelet. I hope this helps! 😄
|
Reply
