Masha Knots Bracelet Question
Reply
|
chloe_27
Bracelet King
 |
4 years, 7 months ago by chloe_27
Hey! So I saw Masha Knots "Meow" bracelet and do any of you know how to do the loop with the two triangle and the two triangle ends at the bottom?\thank you! ❤️ |
|
knottahti
Moderator
 |
4 years, 7 months ago by knottahti
have you tried watching her video on alpha triangle ends? i would highly suggest it!
|
|
chloe_27
Bracelet King
|
4 years, 7 months ago by chloe_27
@knottahti Thank you! I will watch it. But wait theres two.
|
|
knottahti
Moderator
|
4 years, 7 months ago by knottahti
i believe that is because there are two styles: one where you knot onto the base strings like you would an alpha in the triangle and one where you use to base strings like you would with a normal pattern. it depends on preference!!
|
|
arf820
Moderator
 |
4 years, 7 months ago by arf820
she also has an alpha teardrop loop tutorial where she shows how to make a loop and then two triangle ends with the base strings. i don’t think she has a tutorial on ending the bracelet with two triangle ends though i imagine it’s similar to starting it with two triangle ends🙂
|
|
srhamy28
Bracelet King
 |
4 years, 7 months ago by srhamy28
I assume your talking about the blue meow bracelet (pattern #31213) she made, not the other meow one. basically what she did for the start was make a basic loop, leaving some of her leading string on the opposite side. then bring all of your base strings in, like a normal triangle end, leaving you leading string out in the middle. then take your leading string and make a knot either to the right or left onto the first string coming out of your triangle end. then, continue making rows and adding in the strings as you go down the triangle end. do that for both sides. once you finish that, you can just tuck one of the leading strings to the back (which can eventually be cut off) and continue with one of them. then, for the triangle ends at the end of the bracelet, you will need to add in another leading string. I would probably use the leading string that you are using for the bracelet to make one triangle end, then add in the other after that triangle end is made. anyways, to make the triangle end knot over each of your base strings (or half of them if you are doing two triangle ends). then for the next row, leave one out on either side. just repeat this until you run out of base strings. after that, you should have a triangle knotted with strings hanging out of the side. basically just do a normal triangle end to bring them all together. I hope this makes sense, I tried to give the best explanation I could in a somewhat short post.just so you know, I've never actually done this start/end to an alpha. I am just basing this off of the picture she posted, and the brief explanation in her first bracelet helpline video, though I am more than positive that this is how its made. hope it helps. |
|
chloe_27
Bracelet King
|
4 years, 7 months ago by chloe_27
@knottahti@arf820 @shramry28 thank you! u helped me so much! ❤️
|
Reply
