انتهى الخيط اثناء صنع الاسوارة
Reply
waaad_fr
Beginner
waaad_fr
2 years, 2 months ago by waaad_fr
كيف اضيف خيط بعد ان انتهت احد الخيوط قبل ان انهي الاسوارة
Tikilishi
Moderator
Tikilishi
2 years, 2 months ago by Tikilishi
You can replace a string by using a few pieces of tape.

First, tape the new string near or to the back of your bracelet.
Then, move the string you are going to replace far off to the side and tape it down, or clip it out of the way with your clipboard, so that it stays out of the way.
Then, when it's time to tie a knot using the new string, bring it from the back of the bracelet, and tie it onto the correct string, (following the pattern)
After a few rows, it should feel like the new string has been there all along.
Do not remove any tape until you're several rows in with the new string, (I like to do maybe 7 to 10 new rows with the new string)
Then, remove the tape, flip your bracelet to the back side, and using scissors, cut the end of the old string that is peering out of the back of the bracelet.
Reply