Length of strings for an arrowhead bracelet
Reply
|
Jasica22
Professional
 |
2 years, 5 months ago by Jasica22
I'm really confused about the length of strings required for a 6 colored arrowhead bracelet #18. 🤯I made two different bracelets previously and on one of them, there was around 30 CM of waste string so I used ahorter strings for the other one, but I ran out of the string. |
|
Goldfish15
Bracelet King
 |
2 years, 5 months ago by Goldfish15
Personally, I just use a lot of string to ensure that I will not run out. You will have a lot of waste string but I don’t recommend throwing the string away because waste string can still be used.
|
|
halokiwi
Moderator
 |
2 years, 5 months ago by halokiwi
Usually I use about 90cm per string, 180cm if I fold it in half
|
|
rollergirl
Bracelet King
 |
2 years, 5 months ago by rollergirl
Try doing a bit less than what you tried with waste string. Then, adjust, and decide what length works for you and write it down.If you do have waste thread, don’t waste it! Just keep knotting until you run out, and turn it into a bookmark! 😄❤️🤩 |
|
Jasica22
Professional
|
2 years, 5 months ago by Jasica22
@Goldfish15 , @halokiwi and @rollergirl , thanks a lot for help ❤️
|
|
Wonderbubi
Bracelet King
 |
2 years, 5 months ago by Wonderbubi
I always cut my strings about 1m each, but if they're too long, I just keep them and use them for alphas
|
|
smplyjedi
Bracelet King
 |
2 years, 4 months ago by smplyjedi
A lot of ppl say 1-1.5 metres are a good length depending on what bracelet your making, so for an arrowhead I would use about 1 metre.
|
Reply
