What should I do?
Reply
|
Xxbl00dyxX
Bracelet King
 |
3 years, 3 months ago by Xxbl00dyxX
So when I make my bracelets I like to use a clipboard. But I’ve noticed when I finish, it leaves lines on the bracelet and causes my bracelet to curl up a bit because of how it’s clipped down. But I don’t like to tape my bracelets because when I remove the tape it makes them fuzzy. I want to be able to keep using my clipboard because it helps me knot more consistently I just didn’t know how to make it stop curling or leaving marks What do you do when you make your bracelets? |
|
halokiwi
Moderator
 |
3 years, 3 months ago by halokiwi
At least for me these marks aren't permanent, but I think my clipboard has gotten week in general. Maybe you could try to manipulate your clipboard so that it clips less strong.If you want to avoid them you could clip the bracelet down at the loop or at the ties. There a dent shouldn't be a big issue. You could also try to make a protective sleeve out of something, put the bracelet in it and clip it down like that. The bracelet might slip out of the sleeve. |
|
Xxbl00dyxX
Bracelet King
|
3 years, 3 months ago by Xxbl00dyxX
I will usually get scrap string and put it around my loop and tape it down but that only really works when I start the bracelet. As it gets longer and longer it moves around more which I don’t like
|
|
Xxbl00dyxX
Bracelet King
|
3 years, 3 months ago by Xxbl00dyxX
But yeah I think I’ll try to adjust my clipboard
|
|
minutcraft
Bracelet King
 |
3 years, 3 months ago by minutcraft
@Xxbl00dyxX I've observed some people putting something like a metal ruler between their bracelet and the clip. Maybe that will help spread out the pressure on your bracelet?
|
Reply
